Shopping Cart
Your shopping cart is empty!

ECET 380 Week 6 iLab Introduction to OFDM Generation NEW WORK

ECET 380 Week 6 iLab Introduction to OFDM Generation NEW WORK
Model:Latest
Price: $13.00 $10.00
Qty:   Check out
This Tutorial was Purchased: 7  Times   & Rated: A+ by student like you.

attachments This Tutorial contains following Attachments:

  • ECET 380 Week 6 Lab Introduction to OFDM Generation.docx

ECET 380 Week 6 iLab Introduction to OFDM Generation NEW

 

Introduction to OFDM Generation

VIII. OBJECTIVES
1. Introduce the student to the underlying theory of operation of Orthogonal Frequency Division Multiplexing (OFDM).
2. Learn to use TIMS modules to implement an OFDM generator scheme.
3. Generate and analyze OFDM waveforms.

IX. PARTS LIST
Equipment:
IBM PC or Compatible with Windows 2000 or Higher
Software:
TutorTIMS – Version 2.0 Advanced

The following TIMS modules will be required for the lab. Read about the modules required for the particular lab section before proceeding:

11. Sequence Generator
12. Multiplier
13. M-Level Encoder
14. Phase Shifter
15. Master Signals
16. Adder
17. Tunable LPF
18. 100 KHz Channel Filters
19. Decision Maker

X. INTRODUCTION

OFDM (Orthogonal Frequency Division Multiplexing) is a combination of modulation and multiplexing, and more specifically, is a special case of Frequency Division Multiplexing (FDM), as the name implies.  

A single main data stream is split into many lower rate data streams (multiplexing).  Each of these streams is then individually modulated onto a separate sub-carrier (modulation) and finally recombined into a single composite OFDM signal to be transmitted.

The addition of a cyclic prefix is also an important part of OFDM, however, this feature will be discussed but not implemented in this introductory experiment.  The coding blocks will not be covered in detail within this experiment. 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

A   B   C   D   F  

Enter the code in the box below:



Top